Step 6 finish your garage siding with trim.
Garage siding starter course.
Staret strip secures the first course of siding to the home.
From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner.
For wood and cement fiber siding generally use 1 by 4 boards overlapped at the corners.
Hardieplank lap siding requires a starter strip beneath the first course.
Hold a second piece of siding against the j channel at the slope of the gable.
In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level.
You can make your own fiber cement starter strip by ripping a piece of hardieplank lap siding into 1 1 4 inch strips.
Mark the slope with a pencil on the short piece of siding.
This video shows how to install a starter strip for vinyl and polymer siding installation.
Cut vinyl pieces to fit with a saw or snips.
Remove the short piece and cut along the pencil line as a pattern for the gable angle cuts.
Lock a short piece of siding into the gable starter course i e the last course before the gable starts.
It doesn t need to fit exactly in the corner.
Nail the starter strip in place above the drip cap with a coiled nailing sider.
Start with a level chalk line for the bottom starter strip and check the level periodically as you go up.
You have two options here you can make your own or you may be able to find acceptable prefabricated third party starter strips available for purchase.
For the second course leave a 7 1 2 exposure which will cover the end of the notches on the first course.
Below the top of the foundation but the lower the vinyl siding is installed the better.
Use the wider starter strip the bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in.
As shown in the diagram a wooden spacer can be used to provide the proper angle for the first strip.
Learn how to remove an old garage door and install a new one with these detailed step by step instructions.
In this case you ll need to maintain the starter strip height on both sides of the deck and trim the siding to fit above the deck.
This should be nailed every 6 inches with it s lower edge running along the chalk line.
For vinyl use special trim strips which should come with the.
Begin by installing the first row of siding on both sides of the.
Determine the lowest point of the wall that will be sided.
Starter strip is used at the bottom of each side of the home to lock the first course of siding in place.
